RigExpert Stick 230 Antenna Analyzer
The analyzer is designed for measuring SWR (standing wave ratio), return loss, as well as other parameters of cable and antenna systems in the range of 100 kHz to 230 MHz.
The analyzer is designed for measuring SWR (standing wave ratio), return loss, as well as other parameters of cable and antenna systems in the range of 100 kHz to 230 MHz.
Small. Handy. Powerful. Antenna Analyzer
The following tasks are easily accomplished by using this analyzer:
- Rapid check-out of an antenna in the field or stationary conditions.
- Tuning an antenna to resonance.
- Comparing characteristics of an antenna before and after a specific event (rain, hurricane, etc.).
- Measuring capacitance or inductance of reactive loads.
- Power Out
- -10 dBm
- Frequency
- 0.1 - 230 MHz
- RF Out Connector
- UHF (SO-239)
- Step Frequency
- 1kHz
- Sweep Range
- 10kHz
- SWR2AIR Mode
- +
- Reactance Measurement
- +
- Output Amplifier
- CMOS logic chip
- Output Signal Shape
- Square
- SWR Reference impedance
- 25, 50, 75, 100 Ohm
- ADC
- 16-bit
- Batteries
- 1x 18650
- Battery voltage sensor
- +
- External PSU
- from USB
- Display
- Monochrome, 200×200
- Time Domain Reflectometer mode
- Built-in
- Flash memory storing graphs
- 100 memory
- Multilingual support
- +
- Presets for radio amateur bands
- +
Reviews (1) - Review moderation
Analiser mungil & mantap
Report an abuse
Already reported
Analiser antenanya kecil banget, mudah dibawa, mantap...!
By Joko S. the 11/30/2019
You might also like
